التعبئة بالتفريغ الهوائي في التصنيع المركب: نظرة عامة على الفوائد والعملية

Vacuum bagging is an intermediate composite manufacturing technique that dramatically improves the quality of hand-laid laminates by applying atmospheric pressure uniformly to the wet laminate during cure. It bridges the gap between basic open-mold hand lay-up and fully closed-mold processes like RTM.

The Vacuum Bagging Process

1. Standard Lamination: The laminate is laid up in the mold using the conventional hand lay-up or wet lay-up method.
2. Release Film: A perforated or non-perforated peel ply release film is placed over the wet laminate.
3. Breather / Bleeder Fabric: An absorbent breather fabric is placed over the release film to absorb excess resin and distribute vacuum pressure evenly across the bag.
4. Vacuum Bag: A flexible nylon or polyethylene film is placed over everything and sealed to the mold flange with sealant tape.
5. استخدام المكنسة الكهربائية: A vacuum pump creates negative pressure inside the bag (typically 0.8 to 1.0 bar). Atmospheric pressure then pushes down on the bag from the outside.
6. Cure: The laminate cures under sustained vacuum pressure.

Benefits Over Standard Hand Lay-Up

• Higher Fiber Volume Fraction: The pressure consolidates the laminate, squeezing out excess resin and increasing glass-to-resin ratio from ~30:70 to ~45:55.
• Fewer Voids: Vacuum pressure removes entrapped air and volatile gases, producing a denser, void-free laminate.
• Better Mechanical Properties: The higher fiber fraction directly translates to improved strength and stiffness in the finished part.
• Reduced Styrene Emissions: The sealed bag significantly reduces open-air styrene evaporation, improving shop safety.